User Manual

11
5．Getting Started
 About the OPI-4012
The OPI-4012 scanner is set to low power mode by default. Please press and hold down the trigger switch for a
while to activate the scanner. The scanner will not operate if the main battery is empty. Please charge the main
battery using a dedicated AC adapter before getting started. It is also possible to charge the main battery using a
dedicated cradle (CHG-4001).
・ LED and Buzzer Notification
Status
Color
Display
Operating Status Buzzer
Red Lighting
Shows
that the scanner is being charged.
*1
No
Charging
Green
Lighting
The light changes from red to green when
charging is completed.
No
Green Blinking
Shows that the scan or data transmission was
executed normally.
Yes
Red Blinking Shows that the data could not be transmitted. Yes
Scanning
Orange Blinking Shows that the data is being stored in memory. Yes
Green
Continuously
Blinking
Shows that a Bluetooth connection is being made.
No
Green Lighting Shows that a Bluetooth connection is made.. Yes
Bluetooth
Connection
Red Lighting
Shows that the scanner failed to make a Bluetooth
connection.
Yes
Red Lighting
Shows that the scanner has disconnected a
Bluetooth communication.
Yes
Bluetooth
Disconnection
Red Lighting
Shows that a Bluetooth communication is
disconnected for the scanner being in outside of
the communication range.
Yes
* The LED does not turn red when the cradle detects a fully charged battery.
・ Charging Time
Specification Condition
About 3 hours To fully charge an empty battery.
 About Hand Strap
Use the hand strap to avoid dropping the scanner when carrying or using it.
9 Do not swing the scanner around.