User Manual

■ Handshaking Settings

・You can set the handshaking for the communication between the host and the scanner.

・When it is set to “No handshaking”, the reliability of the transmitted data will be lower. It is

recommended to enable ACK/NAK.

9 ACK/NAK No Response

9 ACK/NAK

■ ACK/NAK Timeout Settings

・You can set the timeout for the ACK/NAK sent from the host.

■ Communication Settings

・Communication settings are set to the following by default:

 Bluetooth Device Address Settings: Disabled

 PIN Code Settings: Disabled

 Encryption Settings: Disabled

 Handshaking Settings: No Handshake

 ACK/NAK Timeout Settings: 100 ms

・

The following communication settings can be configured using the attached menu barcode lists.

 Auto connect

 Data memorizing

 Trigger connection

 Press trigger switch time to connect

 Press trigger switch time to disconnect

 Auto disconnect

 Auto reconnect

■ Auto Connect

・You can set the scanner to automatically connect after setting the Bluetooth device address.

■ Data memorizing

・Scanned barcode data will be stored in a memory automatically when the data memorizing setting is

enabled.

・The capacity of the memory is about 100KB.

・When the memory get full while the scanner is outside of the communication range, the scanner

sounds a buzzer and you will not be able to continue the scanning operation.

・The stored data will be transmitted automatically when the scanner returns to the communication

range.

・If you scan the data clear menu barcode [+-MCLR-+] or the IEEE address label while resending the

stored data outside of the communication range, the stored data will be deleted.

・If you disable the data memorizing settings while the scanner is outside of the communication range,

the stored data will be deleted.