User Manual

17
9 The scanner will not carry out the scanning operation if the data memorizing setting is
disabled.
9 Auto reconnect feature will operate in every 20 seconds.
■ Trigger Connection
・You can set the scanner to connect or disconnect by pressing down the trigger key for the set
duration.
■ Press trigger switch time to connect
・This is the time the trigger switch needs to be pressed where after the scanner tries to establish a
connection.
■ Press trigger switch time to disconnect
・This is the time the trigger switch needs to be pressed where after the scanner disconnects.
■ Auto disconnect
・If the scanner is idle for configured time, it will be disconnected.
■ Auto reconnect
・If the scanner is disconnected because it is out side of the communication range, the reader will try
to establish connection during the configured time.
■ Default setting [S0]
・Foregoing settings are set to the following by default:
 Auto Connect: Enabled
 Data Memorizing: Enabled
 Trigger Connection: Disabled
 Press trigger switch time to connect: 3 seconds
 Press trigger switch time to disconnect: 5 seconds
 Auto disconnect: Disabled
 Auto reconnect: 5 minutes