User Manual

■Notes

・ The scanner does not scan any barcodes other than menu barcodes before it is connected to the Bluetooth device.

(If the [BM1] settings are configured, the scanner will scan other barcodes.)

・ If you scan a 12-digit barcode label before connecting the scanner to the Bluetooth device, the scanner will

acknowledge the 12-digit barcode as a Bluetooth device address.

- Before establishing Bluetooth connection:

• A 12-digit barcode label with quiet zones on both ends (Code 39) Æ Acknowledged as a Bluetooth address

• A 12-digit barcode label Æ Acknowledged as a Bluetooth address

- After establishing Bluetooth connection:

• A 12-digit barcode label with quiet zones on both ends (Code 39) Æ Acknowledged as a Bluetooth address

• A 12-digit barcode label Æ Acknowledged as a barcode

・ If the battery voltage gets low, the LED lights red when scanning a barcode. Please charge the scanner.

・ When the scanner is outside of the communication range or when the Bluetooth communication is disconnected, the

LED of the scanner turns solid red and the scanner sounds a buzzer.

・ When the scanner carries out a scanning operation outside of the communication range, the LED of the scanner

turns orange and the buzzer sound changes.

・ When the scanner is set to “data memorizing disabled”, the scanner will not carry out scanning operation outside of

the communication range.

・ When the memory of the scanner gets full while the scanner is outside of the communication range, you will not be

able to continue the scanning operation.

・ The scanner tries to automatically reconnect in every 20 seconds while it is outside of the communication range.

・ When the “trigger connection option” is enabled, the scanner will stop the auto reconnect operation and establish the

connection when the trigger is pressed for the set duration (press trigger switch time to connect).

・ In this case, the stored barcode data will be deleted.

・ Also, if you disable the data memorizing settings while the scanner is outside of the communication range, the stored

data will be deleted.

・ If you use a trigger key to reconnect while the scanner is set to [CA00], the scanner will return to the idle mode and

stored data will be deleted. To reconnect using the trigger key, do not set to [CA00] but set to [CA99] and [BM1].