User Manual

OPR-3301 SS08xxx
11
Default Settings 2: Read Options, Trigger, Buzzer
Item Default Setting
Setting the number of characters Fixed length OFF all codes
Read mode Single read
Multiple read reset time 500 ms
Add-on wait mode 500 ms
Multiple label read Disable
Multiple column read Disable
Redundancy (*1) Read 1 time, redundancy = 0
Trigger switch Enable
Trigger repeat Disable
Auto trigger Disable
Read time 2 seconds (when trigger enabled)
Margin check Normal
Buzzer duration 50 ms
Buzzer loudness 1 (max.)
Start up buzzer After transmission
Good read LED Indicator duration 200 ms
*1: Redundancy: Read n times, redundancy = n+1 for the following symbologies and lengths:
Symbology Number of digit
Code 39 5 or less
NW-7(Codabar) All
IATA 8 or less
Industrial2of5 8 or less
Interleaved2of5 8 or less
MSI/Plessey 4 or less
Code 11 5 or less
Default Settings 3-1: Communication options
Item
Configurations
Destination setting Cradle (RS232C) connection
No reception memory (data correct) setting Disabled
Enable / Disable connection with trigger switch Disabled
Trigger key for connecting hold time setting Disabled
Trigger key for disconnecting hold time setting Disabled
Automatic disconnection time setting Disabled
Automatic re-connection valid time setting 5 minutes
ACK/NAK control Nonprocedural
ACK/NACK 1 second
Wireless
communication
function
PIN code setting enable （接続先 BD アドレス下 4 桁）
BD address automatic connection setting 有効
Authentication 有効（ペアリング処理自動実行）
Bluetooth
Connection
function
Encryption なし
*In the default setting, the cable used to connect CRD-3301 and host is RS232C.
*When connecting CRD-3301 and host via USB, set the destination to cradle (USB-HID).
*Do not set the PC [CNPC] as destination when connecting CRD-3301 and host.