User Manual

English

USING THE PROJECTOR

Contact IT helpdesk

RS232 by Telnet Function

There is alternative RS232 command control way, in projector so called “RS232 by TELNET” for LAN / RJ45

interface.

Quick Start-Guide for “RS232 by Telnet”

Check and get the IP address on OSD of the projector. 

Make sure that the PC / laptop can access the web-page of the projector. 

Make sure that “Windows Firewall” setting is set disabled in case of “TELNET” function ltering out by 

PC / laptop.

Select 1. Start > All Programs.> Accessories > Command Prompt.

Input the command format as follows: 2.

telnet ttt.xxx.yyy.zzz 23 (“Enter” key pressed) ±

(ttt.xxx.yyy.zzz: IP-Address of the projector) ±

If Telnet-Connection ready, and user can have RS232 command input, then “Enter” key pressed, the 3.

RS232 command will be workable.