Projector User's Manual
14
Installation
Warning Indicator
▀■ When the “LAMP” indicator led is lit orange, the projector will
automatically shut down. Please call the nearest Optoma
facility for assistance.
▀■ When the “TEMP” indicator turns red, it indicates the projec-
tor has overheated. The projector will shut down automati-
cally.
Under normal conditions, the projector can be switched on
again after it has cooled down.
▀■ When the “TEMP” indicator ashes red, it indicates the fan
has failed.
Powering Off the Projector
1. Press the “ ” button on the remote control or “ ” button on
the side of the projector two times with one second interval
in between to turn off the projector. First push of button will
display the following message on the screen.
Press the button again to conrm the shut down. If the but-
ton is not pressed, the message will disappear in 5 seconds.
2. The cooling fans continue to operate for about 60 seconds
for cooling cycle and the Power LED will turn blue. When
the lights solid red, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait until
the projector has completed the cooling cycle and has en-
tered standby mode. Once in standby mode, simply press “
” button to restart the projector.
3. Disconnect the power cord from the electrical outlet and the
projector.
4. Do not turn on the projector immediately following a power
off procedure.
Contact the nearest
service center if the
projector displays these
symptoms. See page
49 for more information.
Note
Note