Projector User's Manual

English
3
Usage Notice
Precautions
Please follow all warnings, precautions and main-
tenance as recommended in this user’s guide.
When the lamp reaches
the end of its life, the
projector will not turn
back on until the lamp
module has been
replaced. To replace
the lamp, follow the
procedures listed under
“Replacing the Lamp”
section on page 42.
▀■ Warning-
Do not look into the projector’s lens when the
lamp is on. The bright light may hurt your
eyes.
▀■ Warning-
To reduce the risk of re or electric shock, do
not expose this projector to rain or moisture.
▀■ Warning-
Please do not open or disassemble the projec-
tor as this may cause electric shock.
▀■ Warning-
When replacing the lamp, please allow the
unit to cool down. Follow instructions as
described on page 42.
▀■ Warning-
This projector will detect the life of the lamp it-
self. Please be sure to change the lamp when
it shows warning messages.
▀■ Warning-
Reset the “Lamp Reset” function from the on-
screen display “System|Lamp Setting” menu
after replacing the lamp module (refer to page
34).
▀■ Warning-
When switching the projector off, please
ensure the cooling cycle has been completed
before disconnecting power. Allow 90 seconds
for the projector to cool down.
▀■ Warning-
Do not use lens cap when projector is in
operation.
▀■ Warning-
When the lamp is approaching to the end of its
life time, the message “Replacement suggest-
ed” will show on the screen. Please contact
your local reseller or service center to change
the lamp as soon as possible.
Note
Note