manual

25
The message will show “A
CONFIGURATION FILE IS FOUND!”
Use the same steps as you would in
updating content files to update the
configuration files.
⇒ The message will be shown as the
following picture.
<File replacement screen>
Memo:
• If the message of “must format the
SD card” displays, please format the
SD. memory card. ( page 21)
3. To transmit the content files of
USB memory
After pressing the set button for 3
seconds, the saved content files in SD
memory card will be erased and then
USB memory’s content files will be
transmitted.
⇒ “Upload complete” means the
completion of transmission. After
the transmission, the content files in
SD memory will be replayed
automatically.
Notice:
• During transmission, do not take out
the USB memory from the device.
Memo:
• To cancel the transmission, please
press the set button for fewer
seconds.
• Even though the contents are
replayed, the content files can still be
replaced.
• If the replaying time has been set
beforehand for the transmitted
contents , please replay it following
the instruction of replaying time
setting.
Memo:
• The message shown as the picture
below means the failure of
transmission.
<Screen1 of file replacement error>
⇒ Please press set button and
practice the process from second
step again.
<Screen2 of file replacement error>
⇒ Please press set button and then
change the SD memory card with
enough capacity.
4. Take off the USB memory
Please take out the USB memory from
USB terminal and then put back the
terminal cover.