Use and Care Manual

English
33
USING THE PROJECTOR
Main
Menu
Sub Menu Sub Menu 2 Sub Menu 3 Sub Menu 4 Values
Information
Regulatory
Serial Number
Source
Resolution 00x00
Refresh Rate 0.00Hz
Display Mode
Power mode
(Standby)
Lamp Hours
Bright 0 hr
Eco. 0 hr
Dynamic 0 hr
Eco+ 0 hr
Total
Network Status
IP Address
Projector ID 00~99
Filter Usage
Hours
Brightness
Mode
FW Version
System
LAN
MCU
Note:
 The “Lamp Reset” in OSD will only reset both Lamp Hours in OSD and Lamp Hours in service mode.
The Projection Hours in service mode will not be reset.
 Each display mode can be adjusted and saved the value.
 In 3D timing mode, the zoom/edge mask will be disabled to prevent from image break.
Display menu
Display image settings menu
Display Mode (Data mode)
There are many factory presets optimized for various types of images.
 Presentation: This mode is suitable for showing PowerPoint presentations when the projector is
connected to the PC.
 Bright: Maximum brightness from PC input.
 Cinema: Select this mode for home theater.
 Game: Select this mode to increase the brightness and response time level for enjoying video games.
 sRGB: Standardized accurate color.
 DICOM SIM.: This mode can project a monochrome medical image such as an X ray radiography,
MRI, etc.