Owners manual

English
27
USING THE PROJECTOR
Main menu Sub menu Advanced menu Single-item menu Value
Setup
Audio Settings
Audio Out(Standby)
On Default[Off]
Note:
- Considering power
consumption in active mode,
AudioOut(Standby) supports
only analog audio input
(HDMI audio is out from
AudioInput1).
- End-user can enable / disable
AudioOut(Standby) while
PowerMode(Standby)
is Active, not operate
this function while
PowerMode(Standby) is Eco.
Off
Exit
Advanced
Logo
Default
Neutral
User
Logo Capture
Note:
- Because of ash size
limitation, logo captured by
end-user must be smaller
than 2MB.
- Logo Capture function is
invalid while 3D is On. 3D
image consists of two frame
images, it may cause logo
capture to fail.
- Logo Capture feature should
be used solely for capturing
logos, not complicated
pictures.
Closed Captioning
Off
CC1
CC2
Exit
Network
LAN Settings
Network Status
Connect (Read-Only)
Disconnect (Read-Only)
DHCP
On
Off [Default]
IP Address Default [192.168.0.100]
Subnet Mask Default [255.255.255.0]
Gateway Default [192.168.0.254]
DNS Default [192.168.0.1]
MAC Address Read-Only
Exit
Control Settings
Crestron On / Off (port:41794)
Extron On / Off (port: 2023)
PJLink On / Off (port: 4352)
AMX Device Discovery On / Off (port: 9131)
Telnet On / Off (port: 23)
HTTP On / Off (port: 80)
Exit