User`s guide

English

Powering On / Off the Projector

Powering On the Projector

1. Connect the power cord to the projector.

2. Turn On the connected devices.

3. Ensure the Power LED is steady (ashing) and then press the

Power button to turn On the projector.

The projector splash screen displays and connected devices are

detected. If the connected device is a PC, press the appropriate

keys on the computer keyboard to switch the display output to

the projector. (Check the user manual of the PC to determine the

appropriate Fn key combination to change display output.)

See Setting an Access Password (Security Lock) on page 37

if security lock is enabled.

4. If more than one input device is connected, press the “Source”

button to switch between devices sequentially.

For direct source selection, see page 21.

(DVD and HDTV are supported through the VGA connector)

v Turn on the

projector rst

and then

select the

signal sources.

Installation