User`s guide

English

Installation

Warning Indicator

▀■ When the Lamp LED indicator lights red, the projector will

automatically shut itself down. Please contact your local

reseller or service center. See page 54.

▀■ When the Temp LED is on a steady (not ashing) red, the

projector will automatically shut itself down. Under normal

conditions, the projector can be switched on again after it

has cooled down. If the problem persists, you should contact

your local dealer or our service center. See page 54.

Powering O the Projector

1. Press the " " button on the remote control or "POWER"

button on the panel of the projector to turn o the projector.

First push of button will display the following message on

the screen.

Press the button again to conrm the shut down. If the

button is not pressed, the message will disappear in 5

seconds.

2. The Power LED ashes green (1 sec on, 1sec o) and the

fans will speed up during shut down cooling cycle. The

projector reaches stand-by mode as soon as the Power

LED ashes green (2 sec on, 2 sec o).

If you wish to turn the projector back on, you must wait

until the projector has completed the cooling cycle and

has entered standby mode. Once in standby mode, simply

press "POWER" button on the rear of the projector or " "

on the remote control to restart the projector.

3. Disconnect the power cord from the electrical outlet and the

projector only when the projector is in stand-by mode.

ote

Contact the

nearest service

center if the

projector displays

these symptoms.

See page 82 for

more information.