Operation Manual

49
English
Appendices
The projector stops responding to all controls

If possible, turn off the projector, then unplug the power cord and
wait at least 60 seconds before reconnecting power.

Check that “Keypad Lock” is not activated by trying to control the
projector with the remote control.
Blurry double image

Press the “3D Format” button and switch off 3D to avoid a blurred
image when viewing normal 2D content.
Two images, side-by-side format

Press “3D Format” button and switch to “SBS” for input signal is
HDMI 1.3 2D 1080i side-by-side.
Image does not display in 3D

Check if the battery of 3D glasses is drained.

Check if the 3D glasses is turned on.

When the input signal is HDMI 1.3 2D (1080i side-by-side half),
press “3D Format” button and switch to “SBS”.
Lamp burns out or makes a popping sound

When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replace the
lamp, follow the procedures in the “Replacing the Lamp” section on
pages 52-53.