User manual

How to Use the Digital Signage Processor

How to Use the Digital Signage

Processor

Powering On

Before powering on the Digital Signage Processor, insert an SD card into the

SD card slot.

After performing the necessary connections, you are now

ready to power on your Digital Signage Processor. Press

on the remote control. The LED indicator lights green to

denote power.

Boot Sequence

When you turn on the Digital Signage Processor, it checks the

memory drives connected to your device in a particular order,

this is called the Boot Sequence.

In Slideshow mode, the boot sequence of your Digital Signage

Processor is as follows:

1. Checks the USB drive for USB memory drive connections.

2. Checks the SD card content.

When you accidentally turn on the Digital Signage Processor without any

memory card inserted in the device, a “No Signal” message appears on the

screen. Press on the remote control, then press to reboot the

device again.

Powering Off

To turn off the Digital Signage Processor, press on the

remote control. The LED indicator lights red to denote

standby mode.

Note

POWER ON

Note

STANDBY

POWER ON

STANDBY