User manual

Declaration of Conformity

FCC Notice

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio

communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the

equipment off and on, you are encouraged to try to correct the

interference by one or more of the following measures:

• Reorienting or relocating the receiving antenna.

• Increasing the separation between the equipment and receiver.

• Connecting the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consulting the dealer or an experienced radio or television technician for

help.

This device complies with part 15 of the FCC Rules. Opera-

tion is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including

interference that may cause undesired operation.

CE Marking

This product complies with the principal elements of the safety

objectives of EMC Directive (2004/108/EEC) and the Low Voltage

Directive (2006/95/EC) issued by the Commission of the European

Community. Compliance with these directives implies conformity to

the following European Norms (in parentheses are the equivalent

international standards and regulations):

• EN55022 (CISPR 22). Electromagnetic Interference

• EN55024 (IEC61000-4-2,3,4,5,6,8,11). Electromagnetic Immunity

• EN61000-3-2. (IEC61000-3-2)-Power Line Harmonics