Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
15
SETUP AND INSTALLATION
Adjusting the projector image
Image height
The projector is equipped with elevator feet for adjusting the image height.
Locate the adjustable foot you wish to adjust on the underside of the projector.1.
Rotate the adjustable foot clockwise or anticlockwise to raise or lower the projector.2.
Tilt-Adjustment Feet
Tilt-Adjustment Ring
Zoom and focus
To adjust the image size, turn the zoom lever clockwise or anticlockwise to increase or decrease the
projected image size.
To adjust the focus, turn the focus ring clockwise or anticlockwise until the image is sharp and legible.
Focus Ring
Zoom Lever
The projector will focus at a distance of 1.2m to 8.2m. Note:
WXGA: 24.7” to 302.7” (0.6 to 7.9 meters)
1080p: 25.1” to 309.4” (0.6 to 7.9 meters)
WUXGA: 25.8” to 318” (0.7 to 8.1 meters)