Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
21
USING THE PROJECTOR
Menu navigation and features
The projector has multilingual on-screen display menus that allow you to make image adjustments and change a
variety of settings. The projector will automatically detect the source.
To open the OSD menu, press "Menu" on the Remote Control or Keypad.1.
When OSD is displayed, use 2. keys to select any item in the main menu. While making a selection
on a particular page, press or "Enter" key to enter sub menu.
Use 3. keys to select the desired item in the sub menu and then press or "Enter" key to view
further settings. Adjust the settings by key.
Select the next item to be adjusted in the sub menu and adjust as described above.4.
Press "Enter" or "Menu" to conrm, and the screen will return to the main menu.5.
To exit, press "Menu" again. The OSD menu will close and the projector will automatically save the 6.
new settings.
Sub Menu
Settings
Main Menu
Display Mode
Brightness
Contrast
IMAGE
Sharpness
Color
Tint
Advanced
Presentation