Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
50
USING THE PROJECTOR
Click "Properties".5.
Type in the IP address and Subnet mask, then press "OK".6.
Press the "Menu" button on the projector.7.
Use 8. keys to select SETUP > Network > LAN Settings.
After getting into LAN Settings, input the following connection parameters:9.
DHCP: Off ±
IP Address: 10.10.10.10 ±
Subnet Mask: 255.255.255.255 ±
Gateway: 0.0.0.0 ±
DNS: 0.0.0.0 ±
Press "Enter" to conrm settings.10.
Open a web browser, for example Microsoft Internet Explorer.with Adobe Flash Player 9.0 or higher 11.
installed.
In the Address bar, input the projector's IP address: 10.10.10.10.12.