Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
52
USING THE PROJECTOR
RS232 by Telnet Function
There is alternative RS232 command control way, in projector so called "RS232 by TELNET" for LAN/RJ45
interface.
Quick Start-Guide for "RS232 by Telnet"
Check and get the IP address on OSD of the projector.
Make sure that the PC/laptop can access the web-page of the projector.
Make sure that "Windows Firewall" setting is set disabled in case of "TELNET" function ltering out by
PC/laptop.
Start > All Programs > Accessories > Command Prompt.1.
Input the command format as follows: 2.
telnet ttt.xxx.yyy.zzz 23 ("Enter" key pressed) ±
(ttt.xxx.yyy.zzz: IP-Address of the projector) ±
If Telnet-Connection ready, and user can have RS232 command input, then "Enter" key pressed, the 3.
RS232 command will be workable.