Operation Manual

English

MAINTENANCE

Installing and cleaning the dust lter (optional)

Installing the dust lter

Note: Dust lters are only required/supplied in the selected regions with excessive dust.

Cleaning the dust lter

We recommend you to clean the dust lter every three months. Clean it more often if the projector is used in a

dusty environment.

Procedure:

1. Switch off the power to the projector by pressing “

” on the projector keypad or pressing “ ” on the

remote control.

2. Set the Power switch to the “OFF” position. Then disconnect the power cord.

3. Push the lter cover downwards to remove it.

4. Remove the lter from its compartment.

5. Clean or replace the dust lter.

6. To install the dust lter, reverse the previous steps.