Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
18
USING THE PROJECTOR
Powering on / off the projector
On
Test
Mode
Pattern
Mouse
Switch
Off
F1 F2
AV Mute
ENTER
Source
Volume V Keystone
Info.
VGA1
1
S-Video
2
HDMI1
3
HDMI2
Format Zoom Remote
ID All
VGA2
4
Video
5
DVI
6
BNC
7
YPbPr
8
DisplayPort
9
3D
0
Re-Sync
Menu Pg
or
Lens cap (*)
Powering on
Remove the lens cap(*).1.
Securely connect the power lead and signal/source cable. When connected, the On/Standby LED will 2.
turn amber.
Turn on the projector by pressing the 3. " " either on the projector keypad or the remote control
A start up screen will display in approximately 10 seconds and the On/Standby LED will be solid red.4.
The rst time the projector is turned on you will be asked to select the preferred language, projectionNote:
orientation and a few other settings.