Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
26
USING THE PROJECTOR
Main menu Sub menu Advanced menu Single-item menu Value
"T" SKU only HDBaseT Control
Ethernet
On
Default[Off]
Off
RS232
On
Default[Off]
Off
Setup Network
LAN Settings
Network Status
Connect/Disconnect(Read-
Only)
DHCP On/Off [Default Off]
IP Address Default [192.168.0.100]
Subnet Mask Default [255.255.255.0]
Gateway Default [192.168.0.254]
DNS Default [192.168.0.1]
MAC Address Read-Only
Exit
Control Settings
Crestron On / Off (port:41794)
Extron On / Off (port: 2023)
PJ Link On / Off (port: 4352)
AMX Device Discovery On / Off (port: 9131)
Telnet On / Off (port: 23)
HTTP On / Off (port: 80)
Exit
Options
Input Source
VGA1
PS. HDBaseT only exists in "T"
SKU.
VGA2
Video
S-Video
HDMI1
HDMI2
Displayport
HDBaseT
Exit
Source Lock
On
[Default On]
Off
High Altitude
On
[Default Off]
Off
Information Hide
On [Default Off]
PS. Warning message &
Power off not hide
Off
Keypad Lock
On
[Default Off]
Off
Display Mode Lock
On
[Default Off]
Off
Test Pattern
None
Grid
White
Pattern