Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
29
USING THE PROJECTOR
Image menu
Display Mode
Brightness
Contrast
Sharpness
Color
Tint
Advanced
IMAGE
Presentation
Display Mode
Brightness
Contrast
Sharpness
Color
Tint
Advanced
Presentation
IMAGE
Reset
Exit
Display Mode
There are many factory presets optimized for various types of images.
Presentation : This mode is suitable for showing in front of public in connection to the PC.
Bright : Maximum brightness from PC input.
Movie : This mode is suitable for watching video.
sRGB : Standardized accurate color.
Blackboard : This mode should be selected to achieve optimum color settings when projecting onto a
blackboard (green).
DICOM SIM .: This mode can project a monochrome medical image such as an X ray radiography,
MRI, etc.
User : Memorize user's settings.
3D : To experience the 3D effect, you need to have 3D glasses, make sure your PC/portable device
has a 120 Hz signal output quad buffered graphics card and have a 3D Player installed.
Brightness
Adjust the brightness of the image.
Press the to darken image.
Press the to lighten the image.
Contrast
The contrast controls the degree of difference between the lightest and darkest parts of the picture.
Press the to decrease the contrast.
Press the to increase the contrast.