Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
39
USING THE PROJECTOR
Display 3D menu
3D Mode
DISPLAY
Exit
3D Format
3D Sync. Invert
Off
Auto
Off
3D Mode
Off: Select "Off" to turn off 3D mode.
DLP-Link: Select "DLP-Link" to use optimized settings for DLP Link 3D Glasses.
VESA 3D: Select "VESA 3D" to use optimized setting for VESA 3D Glasses.
3D -> 2D
3D: Display 3D signal.
L (Left): Display the left frame of 3D content.
R (Right): Display the right frame of 3D content.
3D Format
Auto: When a 3D identication signal is detected, the 3D format is selected automatically.
SBS: Display 3D signal in "Side-by-Side" format.
Top and Bottom: Display 3D signal in "Top and Bottom" format.
Frame Sequential: Display 3D signal in "Frame Sequential" format.
Note:
“3D Format” is only supported on 3D Timing on page 69.
“3D Format” is only supported on non-HDMI 1.4a 3D timing.
3D Sync. Invert
Press the "On" to invert left and right frame contents.
Press the "Off" for default frame contents.
Exit
Choose "Exit" to exit the menu.