Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
46
USING THE PROJECTOR
How to use web browser to control your projector
Turn "On" the DHCP option on projector to allow a DHCP server to automatically assign an IP 1.
address.
Open the web browser in your PC and type in the projector's IP address ("Network: LAN Settings > IP 2.
Address").
Enter the user name and password, and click "Login".3.
The projector's conguration web interface opens.
Note:
The default user name and password is “admin”.
The steps in this section base on Windows 7 operating system .
Making a direct connection from your computer to the projector*
Turn "Off" the DHCP option on project.1.
Congure the IP address, Subnet Mask, Gateway, and DNS on projector ("Network: LAN Settings").2.
IP Address
Subnet Mask
Gateway
DNS
Open Network and Sharing Center page on your PC, and assign the identical network parameters to 3.
your PC as set on projector. Click "OK" to save the parameters.
Open the web browser on your PC and type in to the URL eld the IP address, assigned in step 3. 4.
Then press "Enter" key.