Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
65
MAINTENANCE
Replacing the lamp (continued)
6
5
3
1
2
4
7
Procedure:
Switch off the power to the projector by pressing the "1. " button on the remote control or on the
Keypad of the projector.
Allow the projector to cool down for at least 30 minutes.2.
Disconnect the power cord.3.
Unscrew the one screw on the cover. 4. 1
Open the cover. 5. 2
Lift up the lamp handle. 6. 3
Press on the both sides then lift up and remove the lamp cord. 7. 4
Unscrew the one screw on the lamp module. 8. 5
Lift up the lamp handle 9. 6 and remove the lamp module slowly and carefully. 7
To replace the lamp module, reverse the previous steps.10.
Turn on the projector and reset the lamp timer.11.
Lamp Reset: (i) Press "Menu" 12. (ii) Select "OPTIONS" (iii) Select "Lamp Settings"
(iv) Select
"Lamp Reset"
(v) Select "Yes".
Note:
The screw on the lamp cover and the lamp cannot be removed.
The projector cannot be turned on if the lamp cover has not been placed back on the projector.
Do not touch the glass area of the lamp. Hand oil can cause the lamp shatter. Use a dry cloth to clean
the lamp module if it was accidentally touched.