Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
76
ADDITIONAL INFORMATION
Projector dimensions and ceiling mount installation
To prevent damage to your projector, please use the Optoma ceiling mount.1.
If you wish to use a third party ceiling mount kit, please ensure the screws used to attach a mount to 2.
the projector meet the following specications:
Screw type: M4*3
Minimum screw length: 10mm
423.90
100.00 100.00
185.0093.22 70.46
330.91
129.47
294.43129.47
81.02 62.35
15.71
Unit: mm
Lens
Please note that damage resulting from incorrect installation will void the warranty.Note:
Warning:
If you buy a ceiling mount from another company, please be sure to use the correct screw size.
Screw size will vary depending on the thickness of the mounting plate.
Be sure to keep at least 10 cm gap between the ceiling and the bottom of the projector.
Avoid installing the projector near a heat source.