Operation Manual

English
90
ADDITIONAL INFORMATION
Blurry double image
Press "3D Format" button and switch to "Off" to avoid normal 2D image is blurry double image. 
Two images, side-by-side format
Press "3D Format" button and switch to "SBS" for input signal is HDMI 1.3 2D 1080i side-by-side. 
Image does not display in 3D
Check if the battery of 3D glasses is drained. 
Check if the 3D glasses is turned on. 
When the input signal is HDMI 1.3 2D (1080i side-by-side half), press "3D Format" button and switch 
to "SBS".
Other problems
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and wait at least 20 seconds before 
reconnecting power.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this 
happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp,
follow the procedures in the "Replacing the Lamp" section on pages 64-65.
Remote control problems
If the remote control does not work
Check the operating angle of the remote control is within ±15° both horizontally and vertically of on of 
the IR receivers on the projector.
Make sure there are not any obstructions between the remote control and the projector. Move to within 
5 m (16 ft) of the projector.
Make sure batteries are inserted correctly. 
Replace batteries if they are exhausted. 