Operation Manual
Table Of Contents
- SAFETY
- INTRODUCTION
- SETUP AND INSTALLATION
- USING THE PROJECTOR
- Powering on / off the projector
- Selecting an input source
- Menu navigation and features
- OSD Menu tree
- Image menu
- Image Advanced menu
- Image advanced signal (RGB) menu
- Image advanced signal (video) menu
- Display menu
- Display 3D menu
- Setup menu
- Setup Audio Settings menu
- Setup Security menu
- Setup network LAN settings menu
- Setup network control settings menu
- Setup network control settings menu
- Setup advanced menu
- Options menu
- Options menu
- Options menu
- Options lamp settings menu
- Options remote settings menu
- Options advanced menu
- Options optional filter settings menu
- 3D Setup
- maintenance
- additional information
English
92
ADDITIONAL INFORMATION
Power off:
Power Off?
Press Power key again
Lamp warning:
Lamp Warning
Lamp life exceeded.
Temperature warning:
Warning! TEMPERATURE TOO HIGH
Please:
1. Make sure air in and outlets are not blocked.
2. Make sure the environment temperature is under 45 degree C.
If the problem persists in spite of the above.
Please contact a service center for repair.
Fan failed:
Warning! FAN LOCKED
The projector will switch off automatically..
Please contact a service center for repair.
Out of display range:
Out Of Range