Operation Manual
English
20
USING THE PROJECTOR
Powering on / off the projector
ON OFF
21 3
54 6
87 9
Gamma Bright Cont. PIP
0
Info
Mode
Auto
Input
Menu Exit
Hot Key
Shutter
(AV Mute)
Pattern
Focus
Lens H
Lens V
Keystone H
Keystone V
Zoom
Enter
or
Powering on
1. Securely connect the power lead and signal/source cable.
2. Set the Power switch to the “ON” position.
3. Turn on the projector by pressing “
” on the remote control or pressing “ ” on the projector keypad.
The Status LED is Orange with a long blink.
Note: The rst time the projector is turned on, you will be prompted to select the preferred language, projection
orientation, and other settings.
Powering off
1. Turn off the projector by pressing “
” on the projector keypad or pressing “ ” on the remote control.
A warning message will appear on the displayed image.
Powering Off...
Press OFF key to Conrm
2. Press “ ” on the projector keypad or press “ ” on the remote control again to conrm, otherwise the
warning message will disappear after 10 seconds. When you press “ ” on the projector keypad or
press “ ” on the remote control for the second time, the projector will shut down.
3. Set the Power switch to the “OFF” position.
4. Disconnect the power lead from the electrical outlet and the projector.
Note: It is not recommended that the projector is turned on immediately, right after a power off procedure.