Owner's Manual
Table Of Contents
English
27
USING THE PROJECTOR
Powering O
1. Turn o the projector by pressing the “ ” button on the projector keypad or the button on the
remote control. The following message will be displayed:
2. Press the or button again to conrm, otherwise the message will disappear after 15 seconds.
When you press the or button for the second time, the projector will shut down.
3. During the cooling cycle, the power LED is ashing green. When the power LED turns solid red,
this indicates the projector has entered standby mode. If you wish to turn the projector back on, you
must wait until the cooling cycle has nished and the projector has entered standby mode. When the
projector is in standby mode, simply press the “ ” button on the projector or the remote control again
to turn on the projector.
4. Disconnect the power cord from the electrical outlet and the projector.
Note:
It is not recommended that the projector is turned on immediately, right after a power o procedure.
By default, the projector turns o automatically after 20 minutes of inactivity. You can modify the idle
time length in “Auto Power o (min.)” menu in “System Settings Power”. If you want the projector to
enter standby mode instead, disable auto power o and set the sleep time interval in “System Settings
Power Sleep Timer (min.)”.