User's Manual

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and the receiver
(3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
(4) Consult the dealer or an experienced radio/TV technician for help.
The highest SAR value for the personal computer system when next to the body, as described in this
user guide, is 0.690 W/kg. No separation from the body is required when the wireless personal
computer system is in operation, as the SAR measurements were taken with the unit "touching" the
surface of the body.
This device was tested for SAR compliance in the lap held configuration. If the device is purchased
with the WWAN option, a whip antenna is utilized for WWAN coverage. When operating in
WWAN mode, the whip antenna should be pulled out and up to the vertical position. In order to
comply with FCC RF exposure requirements, and to align with the SAR test configuration, users
must use the antenna in the vertical position during WWAN operation.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.
The IEEE 802.11a device for the band 5150-5250 MHz is only for indoor usage, to reduce the
potential for harmful interference to co-channel mobile satellite systems.
Caution: Any changes or modifications not expressly approved by OQO for compliance will void the
user's authority to operate the equipment.