Manual

JEEP WRANGLER

ROCK SLIDER SIDE BARS

INSTALLATION INSTRUCTIONS

87-95 YJ Kit # 84095

97-04 TJ Kit # 84100

WARNING

Read and understand all instructions, warnings, cau-

tions, and notes in this sheet and in your owner’s man-

ual before you install this kit.

A. Before Starting Installation

1. Read all warnings and instructions completely and

carefully before you begin.

2. Check to make sure the kit is complete (refer to the

Kit Parts List at the end of this document).

3. Only install this kit on the vehicle for which it is

intended. If anytime during the installation you

encounter something different from what is outlined

in the instructions, call

technical support at (928)

636-7080.

B. Install Kit

1. Mark drilling locations.

a. Set kit side bar in desired position against frame

side and support. Ensure front mounting flange

of kit side bar is forward of body mount.

b. Level kit side bar in relation to body.

c. Using holes in mounting flanges as a template,

mark drilling locations on side of frame.

d. Remove kit side bar.

2. Drill mounting holes.

a. Center punch each of the marked locations.

b. Drill 5/16” holes in each marked location.

3. Install kit side bar.

a. Install kit side bar using kit bolts. DO NOT over-

tighten kit bolts.

Kit Parts List

Qty. Description

16 Bolt, 3/8” x 1”, self-tapping

2 Side bar, rock slider

Rev. 01, Copyright 08/04 Performance Automotive

Group

NOTE

Parts provided in this kit are prefaced by the word kit

and appear in bold print.

Kit Side Bar