Manualshelf

Handling Instructions

ManualsBrandsOR-PC ManualsElectronicsThe unit is designed for documenting data such as patient information inside and outside of operating theaters, intensive-care wards and similar areas of application. It is supporting the local software environment and it may be part of the IT networ
78910111213141516
14
5.4 In-house repairs
The manufacturer guarantees that the device and accessories have been carefully checked before
leaving the factory. The manufacturer is only responsible for safety-related properties within the
scope of statutory regulations if all work on the product is carried out by service personnel autho-
rized by the manufacturer and the device and accessories are used exclusively in accordance with
their intended use. For this reason, you will find warranty seals on or inside your device. If a seal
is broken, it must be assumed that the warranty is void. Authorized service personnel can only be
trained and certified by ACL.
The equipment is designed so that the components listed in this section can be replaced by the
customer's technical personnel who have completed training in the use of electrical equipment.
Further replacement of components is only possible by ACL, Dräger, or other certified service
partners. For service partner training, service manual, and repair assistance, please contact the
manufacturer contact listed in Section 6.
Improper repairs pose a safety risk. The use of your own setting or adjustment methods that
do not comply with the device specifications or of components not supplied or approved by ACL
is not permitted and may result in damage to the device. Any changes to the device without the
manufacturer's permission, modifications or performance-enhancing measures beyond the origi-
nal settings are not permitted.
If you want to reinstall your device as part of maintenance or repair work, you will find all the dri-
vers you need for this on the ACL website after logging in with your customer login.
Your device requires the ACL driver set 16.
The device has one fuse per phase in the mains filter with the following characteristics:
Manufacturer: Schurter AG
Type 5X20 mm SPT series
Operating voltage 250V AC
Current 4A
Release speed T
Shutdown capacity 1.5kA @ 250V AC
10kA @ 125V AC
To change the fuse, remove the cover cap (orange) on the mains filter as shown in the picture.
Then you can remove defective fuses and replace them with new ones of the same type.