Operation Manual

23
Reset to factory
settings.
Original functionality wanted. Press and hold on/off button (3)
for 10 seconds until all indicator
lights double blink simultaneously.
TOOTHBRUSH
Handle is not
operating
(during first
use).
1. Handle has not been activated.
2. Battery has a very low charge
level; no lights illuminate.
1. Briefly place handle on
plugged-in charging unit. It may
take up to 10 min., until charge
level display (8) flashes.
2. Charge at least for 30 min.
Handle does
not operate
with existing
SmartGuide in
household.
1. Synchronizing with existing
SmartGuide failed.
2. Radio transmission is deacti-
vated; radio transmission display
(7) is turned off.
3. SmartGuide is not compatible
with handle.
4. Two handles are already
assigned to SmartGuide.
5. Function is deactivated via App
feature.
1. Synchronize (existing) handle(s)
(again) via SmartGuide settings
in SmartGuide’s battery com-
partment: Press «h/min» for
3 seconds. Turn on handle that
you want to synchronize. Then
turn on second handle you want
to synchronize. Press «h/min» or
«set» to exit synchronization
mode.
2. Activate radio transmission by
simultaneously pressing on/off
(3) and mode button (4) for
2 seconds until radio transmis-
sion display (7) turns on.
3. Handle cannot be used with
excisting SmartGuide.
4. You can synchronize a total of
2 handles only. Change handles
via SmartGuide settings (see 1.)
5. During use of special App fea-
tures, transmission to Smart-
Guide may be deactivated.
You can also (de)activate any
SmartGuide communication via
App.
1. Short stutter-
ing sounds/
flashing light
every 30 sec-
onds or after
2 minutes.
2. Handle does
not operate
any timer.
1. «Professional timer» or
«2-Minute timer» activated.
2. Timer has been modified/
deactivated via App.
1. Set your timer to 2-Minute timer
(stuttering sounds/flashing light
after 2min); or set your timer to
Professional timer (stuttering
sounds/flashing light every
30 seconds). Follow steps under
«Timer setup».
2. Use App to change timer set-
tings or perform factory reset
(see App Trouble Shootings).
Handle does
not charge and
blinks.
Ambient temperature for charging
is out of valid range (
≤
0 °C and
≥
60 °C).
Recommended ambient tempera-
ture for charging is 5 °C to 35 °C.
90639632_D701_WE_S6-112.indd 2390639632_D701_WE_S6-112.indd 23 24.11.15 14:4924.11.15 14:49
CSS APPROVED Effective Date 18Jan2016 GMT - Printed 04Apr2016 Page 23 of 112