User's Manual

TPM Sensor Installation Instructions
1. Make sure and clean valve stem hole in rim of any corrosion or dirt
2. Remove washer, nut and cap from the valve stem on the sensor.
3. Push valve stem through the rim, install washer, tighten nut to 4 ± 0.5Nm then tighten cap.
4. Holding sensor body down against rim while tighten screw.
Each time a tire is serviced or dismounted, it is imperative to replace the grommet with Orange parts to ensure proper
sealing.
It is imperative to replace the sensor if sensor is externally damaged (especially the plastic bridge part where the valve
stem is connected.)
FCC Notice:
1. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter.
2. Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user authority to operate the equipment.