User's Manual

Manual for Tire Pressure Monitoring Systems, TPMS
17/21
Mode 5 ：
：：
： Single sensor replaced
Step Operation process Photograph
1
Take off the broken sensor and replace it with a new sensor.
( if you are only checking for a signal problem from Mode 4
instructions, there is no need to take off the sensor)
2
Press both the setup key and function key
simultaneously for 5 seconds. The display will flash red, and
a “beep” sound will be heard. You can release the buttons,
and the system will have entered into mode 1. Continue to
repress the function key for four times, and then the system
will switch into mode 5. 。
【
【【
【Function】
】】
】Key
【
【【
【Set】
】】
】Key
3
3-1
It will take about 2 seconds after entering mode 5, the
display will show “5”
3-2
Press setup key to choose tire which new sensor installed,
LED will show Tire No.1 / 2 / 3 / 4.
3-3
When Tire No.1 (RF Tire) needs to be replaced, deflate tire
No.1 under 27 psi (tire low pressure default value) and wait
for the receiver to receive the signal. When Tire No. 1
receives the signal, you will hear “beep”. Then, start inflate
tire No.1, it will keep on “beep” till Tire No. 1 is completely
inflated to normal pressure.
4 After completing all the steps above, System will be back to
monitoring condition automatically.