User's Manual

Manual for Tire Pressure Monitoring Systems, TPMS
2/21
Tire Pressure Monitoring Systems, TPMS
Tire Pressure Monitoring Systems (TPMS) improves safety while driving. Once installed in your
vehicle, the system will automatically monitor your tires in real-time for pressure and temperature.
When any tire’s pressure and/or temperature appear abnormal, the system will, in real-time,
transmit signals to active an alarm and show a digital figure to warn the driver of a problem. The
system aids safety, can extend the tire life and help reduce fuel consumption.
NOTICE
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the factoring measures.
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
Caution: Any changes or modifications in construction of this device which are not expressly
approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna must
not be co-located or operating to conjunction with any other antenna or transmitter.
System Scope of Use and Warnings
Tire Pressure Monitoring System, TPMS
This system is a sensing device designed to measure and display tire operation and / or activate
an alert to the driver when pressure and temperature irregularities are detected. It is the
responsibility of the driver to react promptly and with discretion to alerts. Abnormal tire inflation
pressure should be corrected at the earliest opportunity.
Caution: The system is wireless RF product; therefore, it may not receive a signal due to the poor
environment or incorrect operating or incorrect installation. When the system continually cannot
receive any signal from any tire sensor more than 10 minutes since the system be switch on
power for monitoring, the system will show “ E2 ” and turn on the RED abnormal tire LED light
and alert sound. In this case, it may cause by a RF interference environment, a driver need to
drive the vehicle and leave this place. If the display still cannot receive any correct signal from tire
sensor, then, a driver need to find a nearby qualified tire maintain service for checking and
maintain. It may cause by a tire sensor damages or battery power consumption. (Battery in
normal condition can be used more than 7 year, but in abnormal condition, the tire sensor will
continually send warning signal for drivers, thus it will consumption the battery quickly than
normal prediction.)
System Installation and Usage
Use of the TPMS requires that qualified personnel according to the instructions here have
properly installed it. This system is suitable for use on a passenger car, SUV and 4X4 tires, with
up to maximum cold inflation pressure of 74 Psi (Guage) ,below instruction is Guage value
mentioned.