User's Manual

Manual for Tire Pressure Monitoring Systems, TPMS
21/21
4. The receiver cannot receive signal from any of the four tires after its power is
turned on the numeric values representing tire locations displayed on the screen
all become “E1”.
1. There is interference from other electronic device in the vehicle.
Solution ： Remove other electronic device in the vehicle to determine if there is
other interference.
2. The inner circuits of the display panel has failed.
Solution ： Ask your distributor to have your receiver replaced, reconfigure its ID using the Tire
Switching Mode (Mode IV), and send the failed receiver back to its manufacturer for repair.
5. The buzzer has no sound output.
1. The inner circuits of the receiver has failed.
Solution ： Ask your distributor to have your receiver replaced, reconfigure the IDs
of the tires using the Tire Switching Mode(Mode IV),and then send the failed
receiver back to its manufacturer for repair
6. The pressure (or temperature)values show the wrong tire locations
1. The IDs of the four tires are not configures correctly
Solution ： Ask your installment vendor to reconfigure the IDs of the tires using the
Tire Switching Mode (Mode IV or Mode V).
2. After rotating the tires, it cannot reconfigure the IDs from sensors.
Solution ： Ask your installment vendor to reconfigure the IDs of the tires using the
Tire Switching Mode (Mode IV or Mode V).