User's Manual

16 17
5. Addional Features
5.1 Pause Mode
Your Guardline receiver has the ability to temporarily pause
the funconing of your driveway alarm. This is especially
useful if you don’t want to disturb others as you leave your
house, or if you’ll be working near your sensor and don’t
want your driveway alarm to connually go o.
To put your receiver in pause mode:
5.2 Baery Check
When one or more of the sensor baeries are low, the low-
baery indicator LED will blink every 5 seconds.
To check which sensor has low baeries:
9-degree
(Standard)
Window cover on: Window cover o:
Sensor eld-of-view angles:
12-degree
1
2
1. Hold PAUSE/RESET buon
for a few seconds.
All zones will light up
1. Press and hold BATT CHECK
unl Low Baery LED lights up
2. Release. Zone 1 will ash.
You can now check baery status
of Zone 1
3. Press and hold BATT CHECK.
The zone LED will light up to
signal which sensor(s) paired to
Zone 1 have low baery
If no LEDs light up, all sensors
paired with this zone are good
4. Press LEARN/NEXT to advance
to the next zone
5. Repeat step 3 to check baery
6. Repeat steps 3 & 4 for all zones
7. To exit, press LEARN/NEXT
2. In PAUSE mode, all zone LEDs
will cycle for 30 mins at the
standard seng before returning
back to Live mode. You can press
the PAUSE/RESET buon at
anyme to exit PAUSE mode
Switch 1: pause duraon
Switch 2: pause mode
30 mins
STANDARD mode
Your receiver will
automacally exit Pause
mode once the end of the
pause duraon is reached.
Your receiver will beep
at the end of the pause
duraon, but it will stay in
Pause mode. To exit Pause
mode, press Pause/Reset
buon.
60 mins
MANUAL mode
To change these sengs:
Watch the video:
www.guardlinesecurity.com/baery-check