User Manual

USER MANUAL

ORANGE AMPS

LONDON • ENGLAND

VOICE OF THE WORLD

™

EST. 1968

IN USE

Experiment with the position of the Two Stroke in

your signal chain (e.g. before/after other pedals, in

front of your amplifier or in the effects loop). There

are no rules with this pedal!

When the HI or LO controls are set to 12 o’clock

(unity gain), the corresponding FREQ control will

have no effect. Set both HI and LO to 12 o’clock for

a transparent clean boost where no additional EQ

is required.

POWER

9V Battery Operation

The battery installed at the factory is for testing

purposes. If you notice a drop in performance,

replace the battery. To replace the battery,

unfasten the four screws on the base and secure

the new battery in the battery clip, making sure to

observe the battery’s polarity (+ / -). When

powering the pedal from a 9V battery, disconnect

the input when not in use to prolong battery life.

DC Adaptor

The Two Stroke can be powered by 9 or 12V DC.

Use a regulated AC-DC adaptor fitted with a centre

negative plug (2.1mm). Running at 12V will increase

the headroom and the output volume available.

PAGE 1
IN USE Experiment with the position of the Two Stroke in your signal chain (e.g. before/after other pedals, in front of your amplifier or in the effects loop). There are no rules with this pedal! When the HI or LO controls are set to 12 o’clock (unity gain), the corresponding FREQ control will have no effect. Set both HI and LO to 12 o’clock for a transparent clean boost where no additional EQ is required. POWER 9V Battery Operation The battery installed at the factory is for testing purposes.
PAGE 2
A FREQ Selects the HI frequency (850Hz – 8.5kHz) B HI Controls the boost/cut of the HI frequency (+/- 18dB). 12 o’clock position = unity gain C FREQ Selects the LO frequency (120Hz – 1.2kHz) D LO Controls the boost/cut of the LO frequency (+/- 18dB).