User Manual

ORNG9 Manual

Introduction.

The HobbyKing OrangeRx 9 channel is the first DSM2 compatible receiver to support S. Bus

technology. This gives DSM2 users the ability to use S. Bus Servos, Gyros and flybarless systems.

Features:

Moduation: DSM2

Resolution: 1024/2048

Channels: 9chs + S. Bus (S. Bus can support up to 14 channels depending on your transmitter)

Voltage Range: 3.5V~9.6V

Sat Port: 2 (DSM2 remote receiver only)

Fail Safe types: Two ( Smart safe or Preset Fail safe)

Binding:

Insert a bind plug in BIND/S.BUS port. Then power on receiver, The LED will flash to indicate

that the receiver is in bind mode. Power on your DSM2 Compatible transmitter while holding the

bind button in. Once the receivers LED turns to steady on your receiver has bound. Remove the

power source from your receiver and then remove the bind plug. Power of your transmitter then

turn it on again. Connect the power to your receiver and check that the bind was successful if not

repeat the steps above.

PAGE 1
ORNG9 Manual Introduction. The HobbyKing OrangeRx 9 channel is the first DSM2 compatible receiver to support S. Bus technology. This gives DSM2 users the ability to use S. Bus Servos, Gyros and flybarless systems. Features: Moduation: DSM2 Resolution: 1024/2048 Channels: 9chs + S. Bus (S. Bus can support up to 14 channels depending on your transmitter) Voltage Range: 3.5V~9.
PAGE 2
Fail Safe Setting: Smart safe. Insert the bind plug in your receiver, Power on your receiver and wait for the flashing LED. Power on your transmitter holding the bind button. Once the LED on the receiver is steady on power of the receiver and radio and remove the bind plug. You are no in Smart safe mode. Pre-set fail safe. Insert the bind plug in the receiver. Power on the receiver. Once the LED is flashing remove the bind plug from the receiver.