How to program Orangepip Segments328 with your PC
How to program Orangepip Segments328 with your PC You’ve assembled your Orangepip Segments328 board. Now you need to connect it to your PC or laptop and start programming it. The great thing about the Orangepip Segments328 is that it is an Arduino compatible board that can be programmed with the Arduino IDE. Equipment you will need … Orangepip Segments328 USB A to B cable A Windows-based PC or laptop 1.
Once the download has completed you can access it via your browser, or navigate to where you saved it. Click “Run”. Follow the install instructions, clicking “I Agree”, “Next”, and “Install”. The installer will start unpacking.
After a while, the installer will complete. You are now ready to open the Arduino IDE. 2.0 Start a Sketch Double click on the Arduino icon on the desktop. Connect the Orangepip Segments328 board to your PC or laptop using the USB cable. a. The power LED on the right side of the board will light to indicate that the board now has power. b. Windows will begin to automatically install the drivers and assign the Orangepip board a COM number. c.
3.0 Uploading Blink In true traditional Arduino fashion, upload the Blink sketch. This can be located under “File, Examples, 01. Basics, Blink”. An alternative Blink can be located under “File, Examples, 02. Digital, BlinkWithoutDelay”.
Click “Upload” The IDE will compile, or build, the sketch and if there are no errors, will upload it. Manual Process if the drivers fail to automatically install. 1. 2. 3. 4. 5. 6. 7.
