OTHER MANUAL - Transmitter Modu

ManualsBrandsOrangeRX ManualsFPV2.4Ghz Telemetry Module For Turnigy 9XR Pro (DSMX/DSM2/Walkera Compatible)

RANGE

DSMX/DSM2/D

EVO

2.4GH

UTO

RANSMITTER

ODULE

(JR/T

URNIGY

OMPATIBLE

)

SER

ANUAL

EATURES

• Works with any JR/Turnigy/Taranis compatible module-based transmitter

• 4 modes (selected automatically during binding procedure): DSM2 1024/22ms, DSM2 2048/11ms, DSMX 22ms, DSMX 11ms

• Output power - 70mW

• Easy to access bind button

• Range check mode (1mW)

• Current consumption: 100mA

OMPATIBILITY

Standard JR style 5 pin module-based transmitters (JR/Turnigy compatible)

2.4Ghz protocol: DSMX / DSM2

Input Voltage: 6 - 18VDC

Power: 70mW

Radio Type: Full range system

UTPUT PROTOCOLS

DSM2 –1024/22ms, 2048/11ms

DSMx – 22ms/11ms

X MODULE

NSTALLATION

The Tx module can be installed and used in following radio transmitters:

- All JR compatible radios with external Tx module compartment

- Turnigy 9XR and 9XR Pro

- Taranis X9D and compatible

NTENNA

OLARIZATION AND ORIENTATION

For optimum RF link performance it’s important that the antenna be oriented in the way

that allows for the best possible signal reception when the aircraft is in all possible attitudes and

positions. Follow simple rules:

- Never point antenna to the aircraft. Pointing antenna to the aircraft will give you the worst reception.

- Don’t block an antenna with metal objects (frames, trays, monitor and smartphone holders). This weakens the signal.

- In the most situations it is better to position antenna horizontally to get better performance and avoid pointing antenna to the aircraft.

CHANGE

To make sure that many models can be controlled at the same time and place without interference to each other a unique ID is assigned to

each control communication. A transmitter module provides this ID to the receiver during binding procedure. There is totally more than 4 billion

combinations available. You may want to change ID before binding to another model to make sure that if you accidently turned previous model

ON with settings for the new model, the previous one will not respond to your radio transmitter.

Summary of content (3 pages)

PAGE 1
ORANGERX DSMX/DSM2/DEVO 2.4GHZ AUTO TRANSMITTER MODULE (JR/TURNIGY COMPATIBLE) USER MANUAL FEATURES: • Works with any JR/Turnigy/Taranis compatible module-based transmitter • 4 modes (selected automatically during binding procedure): DSM2 1024/22ms, DSM2 2048/11ms, DSMX 22ms, DSMX 11ms • Output power - 70mW • Easy to access bind button • Range check mode (1mW) • Current consumption: 100mA COMPATIBILITY: Standard JR style 5 pin module-based transmitters (JR/Turnigy compatible) 2.
PAGE 2
RANGE TESTING Before each flying session and especially with a new model, it is important to perform a range check. Make sure that your transmitter battery is fully charged. Be careful and make sure that all propellers on your aircraft are removed. Turn your transmitter on and following turn on your receiver. Make sure that the orange LED on your receiver/satellites is ON and solid. That indicates a good signal received.
PAGE 3
Functionality: Power ON: When powered up the module is waiting for valid PPM signal to be detected. As soon as PPM signal is detected the buzzer generates three short beeps (0.1s) indicating that the system is ready. When module starts transmitting RF packets red LED is will blink according to the mode selected during binding (!). For example if your receiver supports only DSM2, 2048ms and it is bound to the Tx module in this mode, Tx module will produce single blinks during the normal operation.