Use and Care Manual
Table Of Contents
- Contents
- 1. Overview
- 2. Connect to the Network and Access the Router
- 3. Specify Your Internet Settings
- Manually set up the Internet connection
- Specify an Internet connection without a login
- Specify an Internet connection that uses a login
- Manage an IPv6 Internet connection
- Requirements for entering IPv6 addresses
- Specify IPv6 Internet connections
- Use auto detection for an IPv6 Internet connection
- Use auto configuration for an IPv6 Internet connection
- Set up an IPv6 6rd tunnel Internet connection
- Set up an IPv6 6to4 tunnel Internet connection
- Set up an IPv6 pass-through Internet connection
- Set up an IPv6 fixed Internet connection
- Set up an IPv6 DHCP Internet connection
- Set up an IPv6 PPPoE Internet connection
- Change the MTU size
- 4. Control Access to the Internet
- Allow or block access to your network
- Use keywords to block Internet sites
- Delete keywords that are used to block Internet sites
- Avoid blocking on a trusted computer
- Block services from the Internet
- Manage network access control lists
- Schedule when to block Internet sites and services
- Set up security event email notifications
- 5. Optimize Performance
- 6. Specify Network Settings
- View or change WAN settings
- Manage Dynamic DNS
- Set up a default DMZ server
- Change the router’s device name
- Change the LAN TCP/IP settings
- Use the router as a DHCP server
- Disable the DHCP server feature in the router
- Manage reserved LAN IP addresses
- Manage custom static routes
- Specify basic WiFi settings
- Change the WiFi password or security level
- Set up a guest WiFi network
- Change your region
- Use the router as a WiFi access point only
- Set up router mode
- Generate a new backhaul password
- Set up a bridge for a port group or VLAN tag group
- Get Multi-Gig Internet with Internet port aggregation
- 7. Manage Your Network
- Update the router and satellite firmware
- Change the admin password
- Enable admin password reset
- Reset the admin password
- View router status and usage information
- Display Internet port statistics
- Check the Internet connection status
- View satellite status
- View and manage logs of router activity
- View devices connected to the network or edit device information
- View satellites connected to the network or edit satellite information
- Monitor Internet traffic
- Manage the router configuration file
- Set up remote management
- Use remote access
- Remotely access your router using the Orbi app
- 8. Customize Internet Traffic Rules for Ports
- 9. Use VPN to Access Your Network
- 10. Troubleshooting
- 11. Supplemental Information
Table 6. Factory default settings for Orbi router model RBR750 (Continued)
Default SettingFeature
GMT for WW
GMT -8 for NA and CN
GMT +10 for AU
GMT +9 for KO
GMT +8 for PR
GMT +5:30 for IN
Time zone
DisabledTime zone adjusted for daylight
saving time
DisabledSNMP
Firewall
Disabled (except traffic on port 80, the HTTP port)Inbound (communications coming
in from the Internet)
Enabled (all)Outbound (communications going
out to the Internet)
DisabledSource MAC filtering
WiFi
EnabledWiFi communication
See router labelSSID name
WPA2-PSK (AES)Security
EnabledBroadcast SSID
Auto
Note: Maximum wireless signal rate derived from IEEE Standard 802.11
specifications. Actual throughput can vary. Network conditions and
environmental factors, including volume of network traffic, building
materials and construction, and network overhead, lower actual data
throughput rate.
Transmission speed
United States of America; otherwise, varies by regionCountry/region
AutoRF channel 2.4 GHz fronthaul
AutoRF channel 2.4 GHz backhaul
User Manual129Supplemental Information
Orbi Whole Home Tri-Band Mesh WiFi 6 System