Operation Manual

- 56 -

Instruction Manual Athena

English

TIMER PROGRAMMING

• From this menu, indicated by the symbol

, it is possible to establish the installation

ON/OFF parameters (count-down), together with the display of the current installation

zone operating hours.

• When programming installation switch-on, all the zones are in the OFF state until the

programmed date, after which, each will enter the operating mode prior to switch off.

The symbols

and will be shown onscreen in this operating mode.

• When programming installation switch-off, all zones will enter OFF status on the

programmed date. The symbol

will be shown onscreen in this operating mode.

Note: setting the programmed date to zero will exit the switch on/off

countdown mode before the time ﬁ nalises.

• Switch on or off is performed at 00:00. The countdown program acts in all

adjustment zones simultaneously.

• Press [OK] from the timer programming menu to conﬁ gure the countdown program.

• Press the

and keys to select one of the switch on or off modes.

• Conﬁ gure the date by moving through the date ﬁ eld with the

and arrows and

modify the values with the

and . If [--.--.----] appears in the date ﬁ eld, it means

the date has not been conﬁ gured. After conﬁ guring, press [OK] ] to conﬁ rm. Press the

key

to re-establish the main display screen.

Note: the countdown program cannot be enabled once the extension program

has commenced.

• To display the installation operating hours, press the

or keys from the timing

programming menu. The operating hours refer to the temperature zone displayed

before accessing the menu.

Note: The hour counter for the current zone can be zeroed by pressing the [OK]

key for approximately three seconds from the hour counter display menu. The

maximum that can be stored is 65,535 hours.

ESC