Operation Manual

- 59 -

Instruction Manual Athena

English

• Press [OK] to modify the parameters. The modiﬁ able parameter is the one ﬂ ashing.

• Use the

and arrows to select the parameter to be modiﬁ ed and the and

arrows to modify it. Press [OK] to ﬁ nalise the modiﬁ cation and perform the

conﬁ guration.

• On ﬁ nalising the conﬁ guration:

“OK” appears if the conﬁ guration is performed correctly;

if an error is produced, the ﬂ ashing “ERROR” message is displayed next to ﬁ eld that

produced the error (sensor or actuator).

Note: prior to pressing [OK] to commence conﬁ guration, the remote actuator

and/or the remote sensor must exist in the conﬁ guration mode. Use the remote

actuator and sensor speciﬁ cations to view the modes.

Note: the zone conﬁ guration mode also allows veriﬁ cation of whether the bus

peripherals are correctly connected. Press [OK] to enter parameter modiﬁ cation

mode and successively press [OK] again to perform the connection test.

WARNING: a programmed zone can be deleted by entering [---] in the sensor

and actuator ﬁ elds and then pressing [OK]. It is essential to perform this

operation before reconﬁ guring an already programmed zone.

ADV

ESC

ADV

ESC

ADV

ESC