Operation Manual

- 61 -

Instruction Manual Athena

English

BATTERY STATUS

• The battery charge (in percentage) is displayed in this

menu, which is designated by the symbol

• When the batteries are almost exhausted, this symbol

will also appear on the main page. The unit will

continue performing all functions, but will indicate that

the batteries will have to be replaced soon.

WARNING: with an exhausted battery, relay switching, wireless transmission

and bus communications cannot be guaranteed.

• When the batteries are removed, the unit’s screen will switch off to reduce

consumption and allow them to be replaced. All functions except the clock will be

interrupted. Operating time without batteries is approximately two minutes.

• After replacing the batteries, the rest operations must be carried out as described in

the chapter “Initial reset”.

ON/OFF PROGRAMMING

• It is possible to enable or disable the temperature adjustment for each zone from this

menu, designated by the symbol

. By default, all zones are conﬁ gured to “ON”.

• After selecting the desired zone with the

and arrows, press the [OK] key to

modify the conﬁ guration. Use the

and arrows to select the ON or OFF state and

press [OK] again to conﬁ rm it.

Note: on going from OFF to ON, the operating mode will be the one prior to the

OFF state.

ESC