Owner manual

32
32
Install the Base Install the Base
33
33
6. Place the Base in the vehicle seat
(Photo E), making sure the areas
under and behind the Base are clear
of obstructions.
7. If the vehicle seat back is adjustable,
lock the vehicle seat back into the
upright position.
8. Attach both LATCH Connectors
to their corresponding lower
LATCH anchors. With the LATCH
Connector oriented as shown (Photo
F), push it straight onto the metal
bar until you hear and feel a CLICK.
CLICK AND CHECK:
When using the Orbit Infant System, always
pay attention to the CLICK (through sound
and feel) that says you’ve successfully
completed a step. Then, always immediately
follow up with a CHECK by tugging or pulling
what you just clicked into place.
Installing the Base: With LATCH cont’dInstalling the Base: With LATCH cont’d
3. Free the LATCH Connectors from
their storage locations by pressing
the red buttons and pulling them
upwards at the same time. For
ease of installation, extend the
LATCH Belt to its maximum length
by pressing the grey tab on the
adjuster and pulling on the belt
(Photo B).
4. Position the LATCH Belt through the
Belt Guides as shown (Photo C).
5. The LATCH Belt must be secured in
place by the Lock-off Clamp. If it is
not:
- Center the red stitched line of
the LATCH Belt in the middle of
the Lock-Off Clamp (Photo D)
- Close the Lock-Off Clamp and
secure it fi rmly upon the LATCH
Belt by fl ipping the top closure
down into place.
D
E
F
A
B
C